Get free shipping on all oders over $75!

How To Bend Exhaust Pipe On Car

Bending exhaust pipe on a car is a relatively straightforward process, though it does require some special tools and a bit of patience. It is important to be precise when bending exhaust pipes, as slight misalignments can create problems down the road. Here is a step-by-step guide to safely and accurately bending exhaust pipe on a car.

Tools Needed:

– Exhaust pipe bender
– Pipe cutter
– Hacksaw
– Marker
– Tape measure
– Safety glasses

Step 1: Measure the Length of the Pipe

Using a tape measure, measure the length of the exhaust pipe that you need to bend. This will help you determine the type of bender you need and the amount of material you will need to purchase.

Step 2: Cut the Pipe

Using a pipe cutter or hacksaw, cut the exhaust pipe to the desired length. Take care to ensure that the cut is clean and precise.

Step 3: Mark the Bend

Using a marker, draw a line on the exhaust pipe where you want to make the bend. Make sure that the line is straight and level.

Step 4: Set Up the Bender

Set up the bender as per the manufacturer’s instructions. Make sure that the bender is securely attached to the workbench or other flat surface.

Step 5: Insert the Pipe

Carefully insert the exhaust pipe into the bender. Make sure that the pipe is aligned with the bend mark.

Step 6: Bend the Pipe

Slowly and carefully bend the pipe. Make sure that the bend is even and consistent. Go slowly and stop frequently to check the progress of the bend.

Step 7: Check the Bend

Once the bend is complete, check it for accuracy. Make sure that the bend is even and that the pipe is not kinked or damaged in any way.

Step 8: Remove the Pipe

Carefully remove the exhaust pipe from the bender.

Step 9: Install the Pipe

Once the bend is complete, the exhaust pipe can be installed in the vehicle. Make sure to use the appropriate clamps and fasteners for a secure fit.

Bending exhaust pipe on a car is a relatively straightforward process, but it does require some special tools and a bit of patience. Taking the time to measure, cut, and bend the pipe will ensure that everything fits.

Leave a Reply

Your email address will not be published. Required fields are marked *